0380 Magnum XLT Power Bleeder by Motive Products
The 0380 XLT Magnum Power Brake Bleeder includes six adapters enabling you to work on nearly every car & truck whether US or domestic. It includes two universal and four vehicle-specific adapters making it very flexible for those who work on numerous makes and models of vehicles or the shop that sees a variety of cars & truck.
The 0380 includes a 10' long hose which enables you to keep the unit out of your sparkling engine bay and makes it easier to work on a lift or in the shop. Just set the unit on your lift arm while you work and you can easily keep an eye on the fluid level and the unit pressure.
Included with the six adapters are quick-release-fittings which makes adapter changes and installation from job-to-job fast and easy.
Includes the tools you need to bleed brakes and clutches. Pays for itself in just two uses. This kit also provides extra value in that the adapters are less expensive to purchase in kit form than individually.
Note: Unless you bleed or flush braking systems in large quantity, consider the 0260 XLT Power Bleeder Kit. While both kits contain the same adapters, there are three main differences between the 0380 and the 0260. The 0260 has a smaller 1/2 gallon tank, a smaller pump (the tank is smaller so the larger pump isn't required), and a shorter, 6 foot long hose.
Note: Beginning in 2011 the 1105 adapter is cast aluminum.
Application
Fits most Domestic, European, and Import cars, light trucks and Spec Racer Ford. Also fits many Tilton & Wilwood Master Cylinders.
Adapters included
| Part Number | Description |
| MP-1100 | 1100 European Power Bleeder Adapter |
| MP-1103 | 1103 Late Model Chrysler and Dodge Power Bleeder Adapter |
| MP-1105 | 1105 Motive Products Rectangular Universal Power Bleeder Adapter |
| MP-1107 | 1107 Late Model Ford Power Bleeder Adapter |
| MP-1108 | 1108 Late Model Chevy-GM Power Bleeder Adapter |
| MP-1101 | 1101 Motive Products Round, Universal Power Bleeder Adapter |
Specifications
| Manufacturer | Motive Products |
| Mfgr. Part No. | 0380 |
| Brake System Compatability | Manual, Power, ABS, Traction Control |
| Brake Fluid Compatibility | Dot 3, 4, or 5* |
| Tank Capacity | 1 gallon |
| Hose Length | ~10 feet |
| Warranty | 1 Year Factory Warranty |
| Instructions | General Power Bleeder Instructions |
Three simple steps to a firm pedal
Add brake fluid to the Power Bleeder
Connect master cylinder and pressurize
Open bleed screw & purge old fluid & air
Tips
BEFORE YOU START - Before you start bleeding or flushing your brake system, remove the old brake fluid in your master cylinder reservoir with an old, clean, turkey baster or other suction type device and then replace it with fresh fluid. By doing this you'll be certain that the fluid entering the lines is fresh and you'll minimize the amount of new fluid you'll use in order to clean out the old fluid.
PORSCHE - Some Porsche models have vented master cylinder reservoirs. You will need to pinch the soft vent tube or plug the end BEFORE bleeding. Do not pinch hard lines & don't forget to unplug the line when done bleeding.
MERCEDES - Some Mercedes Models have two hard plastic vent nipples incorporated into the plastic master cylinder. You will need to plug these before bleeding. Just take a short piece of rubber fuel line and and some hose clamps. Put each end of the hose on one each of the nipples. Use the hose clamps to keep them in place. Don't forget to remove the byplass loop you've created when you're done bleeding.
